Selectivity index, ratio of IC50 for recombinant human PREP purified from Escherichia coli to IC50 for recombinant mouse FAP purified from HEK293 cell supernatant
Enzymatic Assay: Enzyme activities were determined kinetically in a final volume of 200 μl for 10 minutes at 37° C. by measuring the initial velocities of pNA release (405 nm) from the substrate using a Spectramax plus microtiterplate reader (Molecular devices). One unit of enzyme activity was defined as the amount of enzyme that catalyzes the release of 1 μmol pNA from the substrate per minute under assay conditions. The chromogenic substrate Gly-Pro-p-nitroanilide (100 μmol/l) was used at pH 8.3 for DPP IV, Lys-Ala-p-nitroanilide (1 mmol/l) at pH 5.5 for DPP II, Ala-Pro-p-nitroanilide (300 μmol/l) at pH 7.4 for DPP9 and Ala-Pro-p-nitroanilide (2 mmol/l) at pH 7.4 for FAP activity measurement. To evaluate the endopeptidase activity of FAP and the influence of inhibitors thereon, Z-Gly-Pro-AMC and Z-Gly-Pro-p-nitroanilide were used at a final concentration of 300 and 100 μmol/l, respectively. The substrate concentrations were chosen around the Km value obtained under the assay conditions used. Buffer compositions for the DPP assays were reported before in the purification articles−vide supra. The FAP assay buffer consisted of 50 mM Tris pH7.4 containing 100 mmol/l NaCl and 0.1 mg/ml bovine serum albumin. The PREP activity was measured as described by Brandt et al. using the chromogenic substrate Z-Gly-Pro-p-nitroanilide (0.25 mmol/l) at pH 7.5 in the presence of 10 mmol/l DTT. Test compounds were dissolved and diluted in DMSO (final concentration DMSO during assay 5% v/v) except for FAP where dilution of the inhibitor was done in water. Inhibitors are pre-incubated with the enzyme for 15 min at 37° C. before starting the assay by the addition of substrate. The concentration of enzyme and of inhibitor during the preincubation is double of the final concentration during activity measurement.
Enzymatic Assay: Enzyme activities were determined kinetically in a final volume of 200 μl for 10 minutes at 37° C. by measuring the initial velocities of pNA release (405 nm) from the substrate using a Spectramax plus microtiterplate reader (Molecular devices). One unit of enzyme activity was defined as the amount of enzyme that catalyzes the release of 1 μmol pNA from the substrate per minute under assay conditions. The chromogenic substrate Gly-Pro-p-nitroanilide (100 μmol/l) was used at pH 8.3 for DPP IV, Lys-Ala-p-nitroanilide (1 mmol/l) at pH 5.5 for DPP II, Ala-Pro-p-nitroanilide (300 μmol/l) at pH 7.4 for DPP9 and Ala-Pro-p-nitroanilide (2 mmol/l) at pH 7.4 for FAP activity measurement. To evaluate the endopeptidase activity of FAP and the influence of inhibitors thereon, Z-Gly-Pro-AMC and Z-Gly-Pro-p-nitroanilide were used at a final concentration of 300 and 100 μmol/l, respectively. The substrate concentrations were chosen around the Km value obtained under the assay conditions used. Buffer compositions for the DPP assays were reported before in the purification articles−vide supra. The FAP assay buffer consisted of 50 mM Tris pH7.4 containing 100 mmol/l NaCl and 0.1 mg/ml bovine serum albumin. The PREP activity was measured as described by Brandt et al. using the chromogenic substrate Z-Gly-Pro-p-nitroanilide (0.25 mmol/l) at pH 7.5 in the presence of 10 mmol/l DTT. Test compounds were dissolved and diluted in DMSO (final concentration DMSO during assay 5% v/v) except for FAP where dilution of the inhibitor was done in water. Inhibitors are pre-incubated with the enzyme for 15 min at 37° C. before starting the assay by the addition of substrate. The concentration of enzyme and of inhibitor during the preincubation is double of the final concentration during activity measurement.
Enzymatic Assay: Enzyme activities were determined kinetically in a final volume of 200 μl for 10 minutes at 37° C. by measuring the initial velocities of pNA release (405 nm) from the substrate using a Spectramax plus microtiterplate reader (Molecular devices). One unit of enzyme activity was defined as the amount of enzyme that catalyzes the release of 1 μmol pNA from the substrate per minute under assay conditions. The chromogenic substrate Gly-Pro-p-nitroanilide (100 μmol/l) was used at pH 8.3 for DPP IV, Lys-Ala-p-nitroanilide (1 mmol/l) at pH 5.5 for DPP II, Ala-Pro-p-nitroanilide (300 μmol/l) at pH 7.4 for DPP9 and Ala-Pro-p-nitroanilide (2 mmol/l) at pH 7.4 for FAP activity measurement. To evaluate the endopeptidase activity of FAP and the influence of inhibitors thereon, Z-Gly-Pro-AMC and Z-Gly-Pro-p-nitroanilide were used at a final concentration of 300 and 100 μmol/l, respectively. The substrate concentrations were chosen around the Km value obtained under the assay conditions used. Buffer compositions for the DPP assays were reported before in the purification articles−vide supra. The FAP assay buffer consisted of 50 mM Tris pH7.4 containing 100 mmol/l NaCl and 0.1 mg/ml bovine serum albumin. The PREP activity was measured as described by Brandt et al. using the chromogenic substrate Z-Gly-Pro-p-nitroanilide (0.25 mmol/l) at pH 7.5 in the presence of 10 mmol/l DTT. Test compounds were dissolved and diluted in DMSO (final concentration DMSO during assay 5% v/v) except for FAP where dilution of the inhibitor was done in water. Inhibitors are pre-incubated with the enzyme for 15 min at 37° C. before starting the assay by the addition of substrate. The concentration of enzyme and of inhibitor during the preincubation is double of the final concentration during activity measurement.
Enzymatic Assay: Enzyme activities were determined kinetically in a final volume of 200 μl for 10 minutes at 37° C. by measuring the initial velocities of pNA release (405 nm) from the substrate using a Spectramax plus microtiterplate reader (Molecular devices). One unit of enzyme activity was defined as the amount of enzyme that catalyzes the release of 1 μmol pNA from the substrate per minute under assay conditions. The chromogenic substrate Gly-Pro-p-nitroanilide (100 μmol/l) was used at pH 8.3 for DPP IV, Lys-Ala-p-nitroanilide (1 mmol/l) at pH 5.5 for DPP II, Ala-Pro-p-nitroanilide (300 μmol/l) at pH 7.4 for DPP9 and Ala-Pro-p-nitroanilide (2 mmol/l) at pH 7.4 for FAP activity measurement. To evaluate the endopeptidase activity of FAP and the influence of inhibitors thereon, Z-Gly-Pro-AMC and Z-Gly-Pro-p-nitroanilide were used at a final concentration of 300 and 100 μmol/l, respectively. The substrate concentrations were chosen around the Km value obtained under the assay conditions used. Buffer compositions for the DPP assays were reported before in the purification articles−vide supra. The FAP assay buffer consisted of 50 mM Tris pH7.4 containing 100 mmol/l NaCl and 0.1 mg/ml bovine serum albumin. The PREP activity was measured as described by Brandt et al. using the chromogenic substrate Z-Gly-Pro-p-nitroanilide (0.25 mmol/l) at pH 7.5 in the presence of 10 mmol/l DTT. Test compounds were dissolved and diluted in DMSO (final concentration DMSO during assay 5% v/v) except for FAP where dilution of the inhibitor was done in water. Inhibitors are pre-incubated with the enzyme for 15 min at 37° C. before starting the assay by the addition of substrate. The concentration of enzyme and of inhibitor during the preincubation is double of the final concentration during activity measurement.
Enzymatic Assay: Enzyme activities were determined kinetically in a final volume of 200 μl for 10 minutes at 37° C. by measuring the initial velocities of pNA release (405 nm) from the substrate using a Spectramax plus microtiterplate reader (Molecular devices). One unit of enzyme activity was defined as the amount of enzyme that catalyzes the release of 1 μmol pNA from the substrate per minute under assay conditions. The chromogenic substrate Gly-Pro-p-nitroanilide (100 μmol/l) was used at pH 8.3 for DPP IV, Lys-Ala-p-nitroanilide (1 mmol/l) at pH 5.5 for DPP II, Ala-Pro-p-nitroanilide (300 μmol/l) at pH 7.4 for DPP9 and Ala-Pro-p-nitroanilide (2 mmol/l) at pH 7.4 for FAP activity measurement. To evaluate the endopeptidase activity of FAP and the influence of inhibitors thereon, Z-Gly-Pro-AMC and Z-Gly-Pro-p-nitroanilide were used at a final concentration of 300 and 100 μmol/l, respectively. The substrate concentrations were chosen around the Km value obtained under the assay conditions used. Buffer compositions for the DPP assays were reported before in the purification articles−vide supra. The FAP assay buffer consisted of 50 mM Tris pH7.4 containing 100 mmol/l NaCl and 0.1 mg/ml bovine serum albumin. The PREP activity was measured as described by Brandt et al. using the chromogenic substrate Z-Gly-Pro-p-nitroanilide (0.25 mmol/l) at pH 7.5 in the presence of 10 mmol/l DTT. Test compounds were dissolved and diluted in DMSO (final concentration DMSO during assay 5% v/v) except for FAP where dilution of the inhibitor was done in water. Inhibitors are pre-incubated with the enzyme for 15 min at 37° C. before starting the assay by the addition of substrate. The concentration of enzyme and of inhibitor during the preincubation is double of the final concentration during activity measurement.