Determine the necessary mass, volume, or concentration for preparing a solution.
Basic Description
| Legal Information | Lumisizer is a trademark of LUM GmbH |
|---|---|
| Storage Temp | Room temperature |
| Shipped In | Normal |
| Product Description | Description This product is a conductive ink based on single-crystal silver nanoparticles in a mixture of propylene glycol monomethyl ether - diethylene glycol monomethyl ether solvents (PM-DGME), has been designed for Aerosol digital printing systems and low temperature sintering applications. The ink offers a unique combination of properties, including high silver loading, low viscosity, storage at ambient conditions, long shelf life, reliable jetting and good printability. Printed patterns, sinterable at low temperatures, provide low electrical resistivity, good adhesion to a wide range of substrates and durability to humid and aqueous environments.This product can be stored at room temperature.Compatible printheadsInk works well with printheads: Air BrushProduct fit for:Digital Printing (Aerosol)Printed Electronics: FPD, RFID, PCBAerosol Jet can print conformal interconnects on 3D surfaces eliminating the need for wire bonding - for example printing electrical connections on 3D stacked die or for LED chip fabrication. Components can also be printed onto 3 dimensional surfaces eliminating the need for a separate substrate thereby reducing the size, thickness and weight of the end product. For example, Aerosol Jet is used to print antennas and sensors that conform to the shape of the underlying substrate such as a cell phone case. The Aerosol Jet process also supports printing on a wide variety of substrates including plastics, ceramics and metallic structures. Preparation instructions Mix well before use.Electrical PropertiesSintering conditions (on glass) :UV followed by thermal (UV 9 W/cm2, 2 min (+), Thermal: 130°C/60 min)Resistivity after sintering conditions mentioned above : ≤10 μΩ·cm (≤6 bulk)Adhesion to (tested) :Kapton, PC, PC/ABS, PA, glassReliability :Adhesion survived below testing conditions (on glass):soaking in NaCl 1M for 2 hsoaking in NaCl 1M for 2 h and in DI water for 20 h |
Certificates
Certificate of Analysis(COA)
Enter Lot Number to search for COA: